Rheem Furnace Error Codes

40 Rheem Furnace error codes and diagnostic codes, with causes and troubleshooting steps for each. Select a code, or find your model below.

Homeowner with a furnace problem? Call (647) 657-2977 or book a service call — licensed technicians across Vaughan and the GTA.

Rheem Furnace error codes list

Find codes by Rheem model

Rheem 90RJ/90TJ 90 Plus

90RJ0490RJ0690RJ0790RJ0990RJ1090RJ1290TJ0490TJ0690TJ0790TJ0990TJ1090TJ12

R95P

R95PA0401317MSAR95PA0601317MSAR95PA0701317MSAR95PA0851521MSAR95PA1001521MSAR95PA1151524MSA

Rheem/Ruud 802P / 80MDP 80% two-stage furnace (UT 1028-928 IFC)

R802PA050314MSAR802PA075417MSAR802PA100521MSAR802PA125524MSAR802PA150524MSA

RGPE/RGLE

RGLE-05(-)BMKRRGLE-07(-)AMKRRGLE-07(-)BRQRRGLE-10(-)BRMRRGLE-12(-)ARMRRGPE-05(-)BMKRRGPE-07(-)AMKRRGPE-07(-)BRQRRGPE-10(-)BRMRRGPE-12(-)ARMR

Rheem (-)GRC/(-)GTC 90 Plus

RGRC-04EMAESRGRC-06EMAESRGRC-07EMAESRGRC-07ERBGSRGRC-09EZAJSRGRC-10EZAJSRGTC-04EMAESRGTC-06EMAESRGTC-07ERBGSRGTC-09EZAJSRGTC-10ERBJS

Rheem RGRM/RGTM 90 Plus

RGRM-04RGRM-06RGRM-07RGRM-09RGRM-10RGRM-12RGTM-06RGTM-07RGTM-09RGTM-10

Furnace troubleshooting guides

• Blowing cold air All brands · Furnace
• No heat All brands · Furnace
• Short cycling All brands · Furnace
• Blower does not start after burners light Rheem · Furnace
• Burners go out before the heat call ends / short cycling Rheem · Furnace
• Communicating system not found / no communication Rheem · Furnace
• ECM blower does not start on heat Rheem · Furnace
• Furnace no heat - sequence troubleshooting Rheem · Furnace
• Furnace short cycles or does not hold setpoint Rheem · Furnace
• Gas valve does not shut off when heat call ends Rheem · Furnace
• Indoor blower does not start after burners light Rheem · Furnace
• Inducer (draft motor) does not start on heat call Rheem · Furnace
• Inducer does not run / does not run on low speed Rheem · Furnace
• Inducer runs 60 s then shuts off for 5 minutes, or runs continuously Rheem · Furnace
• Inducer runs 60 seconds then off for 5 minutes Rheem · Furnace
• No heat - inducer (IDM) does not start Rheem · Furnace
• No heat - POWER LED off Rheem · Furnace
• Read target airflow from the CFM LED Rheem · Furnace
• Thermostat does not hold room temperature Rheem · Furnace

Rheem Furnace specs and setup data

• Clearance to combustibles (all models) Rheem · Furnace · R95P
• Minimum clearance to combustibles Rheem · Furnace · Rheem 90RJ/90TJ 90 Plus
• Minimum clearance to combustibles Rheem · Furnace · Rheem (-)GRC/(-)GTC 90 Plus
• Reduced clearance to combustibles (Fig. 3 and 4) Rheem · Furnace · RGPE/RGLE
• Reduced clearance to combustibles, upflow/horizontal (Fig. 4) Rheem · Furnace · Rheem/Ruud 802P / 80MDP 80% two-stage furnace (UT 1028-928 IFC)
• Filter sizes Rheem · Furnace · Rheem RGRM/RGTM 90 Plus
• Filter sizes (Table 9) Rheem · Furnace · Rheem (-)GRC/(-)GTC 90 Plus
• Filter sizes (Table 12) Rheem · Furnace · Rheem 90RJ/90TJ 90 Plus
• Filter sizes as shipped, upflow (Table 19) Rheem · Furnace · RGPE/RGLE

Homeowner help: Furnace Not Turning On: What to Check · Furnace Blinking Light: What the Flash Codes Mean