Rheem R802PA075417MSA Error Codes

Rheem R802PA075417MSA error codes and diagnostic codes (also listed as U802PA075417MSA, (-)802PA075417MSA, 802PA075417MSA, (-)(-)80MDP075B30SA). The R802PA075417MSA is a Rheem furnace in the Rheem/Ruud 802P / 80MDP 80% two-stage furnace (UT 1028-928 IFC) series.

Homeowner with a furnace problem? Call (647) 657-2977 or book a service call — licensed technicians across Vaughan and the GTA.

Rheem R802PA075417MSA error codes list

Troubleshooting the R802PA075417MSA

• Blowing cold air All brands · Furnace
• No heat All brands · Furnace
• Short cycling All brands · Furnace
• Blower does not start after burners light Rheem · Furnace
• Burners go out before the heat call ends / short cycling Rheem · Furnace
• Communicating system not found / no communication Rheem · Furnace
• ECM blower does not start on heat Rheem · Furnace
• Furnace no heat - sequence troubleshooting Rheem · Furnace
• Furnace short cycles or does not hold setpoint Rheem · Furnace
• Gas valve does not shut off when heat call ends Rheem · Furnace
• Indoor blower does not start after burners light Rheem · Furnace
• Inducer (draft motor) does not start on heat call Rheem · Furnace
• Inducer does not run / does not run on low speed Rheem · Furnace
• Inducer runs 60 s then shuts off for 5 minutes, or runs continuously Rheem · Furnace
• Inducer runs 60 seconds then off for 5 minutes Rheem · Furnace
• No heat - inducer (IDM) does not start Rheem · Furnace
• No heat - POWER LED off Rheem · Furnace
• Read target airflow from the CFM LED Rheem · Furnace
• Thermostat does not hold room temperature Rheem · Furnace

Rheem R802PA075417MSA specs and setup data

• Reduced clearance to combustibles, upflow/horizontal (Fig. 4) Rheem · Furnace · Rheem/Ruud 802P / 80MDP 80% two-stage furnace (UT 1028-928 IFC)

All Rheem Furnace error codes →

Homeowner help: Furnace Not Turning On: What to Check · Furnace Blinking Light: What the Flash Codes Mean