Rinnai Error Code 220: Gas valve position not detected (reed switch) (Boiler)
Rinnai error code 220 on a boiler means: Gas valve position not detected (reed switch). It is also called Rinnai diagnostic code 220.
Homeowner? What Rinnai code 220 means for you
Check, then call Your boiler is reporting: Gas valve position not detected (reed switch). This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Make sure the unit has power: its on/off switch (often looks like a light switch near the unit) is ON and the breaker in the electrical panel is not tripped.
- Look at the pressure gauge on the boiler. If it reads much lower than usual or near zero, or water is leaking, call a technician.
- Outside, make sure the intake and exhaust pipes or vent cap are not blocked by snow, ice, leaves or a nest.
- Check that the boiler gas valve is open (handle in line with the pipe).
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Rinnai error code 220 mean?
The reed switches (sensors) cannot detect the correct position of the gas valve.
Applies to: I-Series Plus boilers — 150K BTU and smaller (Combi and Solo)
Common causes of Rinnai code 220
- Reed switch mispositioned on the front of the gas valve
- Incorrect gas valve parameters
- Loose, damaged or wet wiring between reed switch and PC Board
Rinnai models that use code 220
Other Rinnai Boiler codes
All Rinnai Boiler error codes →
Rinnai code 220: homeowner questions
What does Rinnai code 220 mean?
Gas valve position not detected (reed switch). The reed switches (sensors) cannot detect the correct position of the gas valve.
Is it safe to keep using my boiler with code 220?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset Rinnai code 220 myself?
You can try one reset (power off for 30 seconds, then on). If Rinnai code 220 comes back, the cause is still there and a licensed technician should check it.
Who can fix Rinnai code 220 near me?
Aurora Star Tech Inc. repairs Rinnai boilers in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: Boiler Not Heating: What to Check
Troubleshooting guides
- No heat or some zones cold All brands · Boiler
Source: Rinnai Troubleshooting I-Series Plus Boiler Diagnostic Codes (800000375), p.14–15. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.