Rinnai Error Code 210: Data transfer error (Combi Boiler)
Rinnai error code 210 on a combi boiler means: Data transfer error. It is also called Rinnai diagnostic code 210.
Homeowner? What Rinnai code 210 means for you
Check, then call Your combi boiler is reporting: Data transfer error. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Make sure the unit has power: its on/off switch (often looks like a light switch near the unit) is ON and the breaker in the electrical panel is not tripped.
- Look at the pressure gauge on the boiler. If it reads much lower than usual or near zero, or water is leaking, call a technician.
- Outside, make sure the intake and exhaust pipes or vent cap are not blocked by snow, ice, leaves or a nest.
- Check that the boiler gas valve is open (handle in line with the pipe).
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
- If only hot water is missing, check that the hot water tap is open far enough to start the heater.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Rinnai error code 210 mean?
Indicates a problem with transferring PC Board data, typically after a PC Board replacement.
Applies to: I-Series Plus boilers — 150K BTU and smaller (Combi and Solo)
Common causes of Rinnai code 210
- Incomplete data transfer after PC Board replacement
- Parameters not programmed for the boiler model
- Data transfer instructions not followed
Rinnai models that use code 210
IP060160CIP090099CIP090160CIP090199CIP120199CIP150199C
Other Rinnai Combi Boiler codes
All Rinnai Combi Boiler error codes →
Rinnai code 210: homeowner questions
What does Rinnai code 210 mean?
Data transfer error. Indicates a problem with transferring PC Board data, typically after a PC Board replacement.
Is it safe to keep using my combi boiler with code 210?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset Rinnai code 210 myself?
You can try one reset (power off for 30 seconds, then on). If Rinnai code 210 comes back, the cause is still there and a licensed technician should check it.
Who can fix Rinnai code 210 near me?
Aurora Star Tech Inc. repairs Rinnai combi boilers in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: Tankless Water Heater No Hot Water: What to Check · Boiler Not Heating: What to Check
Source: Rinnai Troubleshooting I-Series Plus Boiler Diagnostic Codes (800000375), p.13. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.