Lennox Error Code 507: PureAir filter calibration failure (Air Handler)
Lennox error code 507 on a air handler means: PureAir filter calibration failure. It is also called Lennox diagnostic code 507.
Homeowner? What Lennox code 507 means for you
Check, then call Your air handler is reporting: PureAir filter calibration failure. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Make sure the unit has power: its on/off switch (often looks like a light switch near the unit) is ON and the breaker in the electrical panel is not tripped.
- Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Lennox error code 507 mean?
Filter calibration failed: all test CFM static pressures read 7 Pa or less; no filter tests or life calculation while active. S30/S40 thermostat alert code 507.
Applies to: Lennox communicating air handlers and EIM-equipped indoor units in S30/S40 smart thermostat systems
Common causes of Lennox code 507
- PureAir S accessory issue
Other Lennox Air Handler codes
All Lennox Air Handler error codes →
Lennox code 507: homeowner questions
What does Lennox code 507 mean?
PureAir filter calibration failure. Filter calibration failed: all test CFM static pressures read 7 Pa or less; no filter tests or life calculation while active. S30/S40 thermostat alert code 507.
Is it safe to keep using my air handler with code 507?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset Lennox code 507 myself?
You can try one reset (power off for 30 seconds, then on). If Lennox code 507 comes back, the cause is still there and a licensed technician should check it.
Who can fix Lennox code 507 near me?
Aurora Star Tech Inc. repairs Lennox air handlers in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Troubleshooting guides
- Two horizontal lines on display (soft disable) - Lennox communicating Lennox · Air Handler
Source: Lennox Residential Communicating Systems Alert Code Guide (V2) 100017 (3/2023), Table 2 Alert Codes and Troubleshooting, p.44. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.