Icon
Reliable Heating and Cooling Solutions – Quality Service, Fair Prices, Guaranteed Satisfaction!

Gree Error Code dL: Indoor discharge air sensor open or shorted (15K) (Heat Pump)

Updated · by Aurora Star Tech Inc.

Gree error code dL on a heat pump means: Indoor discharge air sensor open or shorted (15K). It is also called Gree diagnostic code dL.

Medium severityHeat PumpGree GMV6 Mini VRF

Homeowner? What Gree code dL means for you

Check, then call Your heat pump is reporting: Indoor discharge air sensor open or shorted (15K). This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.

Safe things you can check yourself

  • Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
  • Check both breakers and the outdoor disconnect box beside the outdoor unit; all should be ON.
  • Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
  • In winter, keep snow and ice off and away from the outdoor unit. A short defrost cycle with steam is normal.
  • Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.

Call (647) 657-2977Book a service call

Licensed technicians serving Vaughan, Toronto and the GTA.

What does Gree error code dL mean?

The indoor discharge air thermistor (15K, indoor) reads open or shorted.

Applies to: Gree GMV6 Ultra Heat Mini VRF 36-60k (GMV-V..WL/C-T(U))

Common causes of Gree code dL

  • Sensor or plug fault
  • Wire damage
  • Board fault
Safety: Gas, electrical and refrigerant work must be done by a licensed technician. Turn off power and gas before servicing, never bypass a safety control, and always follow the manufacturer's manual for your exact model.

Gree models that use code dL

GMV-V36WL/C-T(U)GMV-V48WL/C-T(U)GMV-V60WL/C-T(U)

Other Gree Heat Pump codes

CodeMeaning
d5Indoor coil middle pipe sensor open or shorted (20K)
d6Indoor coil outlet pipe sensor open or shorted (20K)
d9Indoor jumper cap fault
dCIndoor capacity DIP setting wrong
ddWiring/EEV check running (status)
dHWired controller board fault
dnWrong interconnect wiring or EEV fault
E0Outdoor unit fault (shown with another code)
E1High pressure protection
E2Indoor coil freeze protection (status)
E3Low pressure protection
E4Compressor discharge temperature too high

All Gree Heat Pump error codes →

Gree code dL: homeowner questions

What does Gree code dL mean?

Indoor discharge air sensor open or shorted (15K). The indoor discharge air thermistor (15K, indoor) reads open or shorted.

Is it safe to keep using my heat pump with code dL?

It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.

Can I reset Gree code dL myself?

You can try one reset (power off for 30 seconds, then on). If Gree code dL comes back, the cause is still there and a licensed technician should check it.

Who can fix Gree code dL near me?

Aurora Star Tech Inc. repairs Gree heat pumps in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.

Homeowner help: AC Running But Not Cooling: What to Check · Heat Pump Not Heating or Blowing Cold Air

Troubleshooting guides

Source: Gree GMV6 Ultra Heat Mini VRF 36-60k (GMV-V36-48-60WL-C-T(U)) service.pdf - section Chapter 3 Faults, 4.1 Error Indication. Written in our own words as a summary; always check the original manual.

General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.

Emergency HVAC Service

647-657-2977