Carrier Error Code PC0F: PFC module protection (Mini-Split)
Carrier error code PC0F on a mini-split means: PFC module protection. It is also called Carrier diagnostic code PC0F.
Homeowner? What Carrier code PC0F means for you
Call a technician Your ductless mini-split is reporting: PFC module protection. The ductless mini-split has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.
Safe things you can check yourself
- Check the remote: fresh batteries and the right mode (Cool, Heat or Auto).
- Check the breaker and the outdoor disconnect; both should be ON.
- Open the front cover of the indoor unit and rinse the washable filters if they are dusty; let them dry before putting them back.
- Keep the outdoor unit clear of snow, ice and leaves.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Carrier error code PC0F mean?
The PFC module signal to the main board is abnormal and the unit stops. Outdoor board shows E6 (it also shows E6 when this happens 3 times in 15 minutes); 48K HH shows J3.
Applies to: DLCM(R/H)B multi-zone outdoor units with DLFSHBH high wall indoor units (Midea, Carrier, Viessmann)
Common causes of Carrier code PC0F
- Loose PFC cable
- Bad PFC inductor
- Bad PFC (IPM) module
A technician checks these and 1 other possible causes on site before replacing any part.
Carrier models that use code PC0F
DLCMHBH24CAKDLCMHBH30DAKDLCMHBH36DAKDLCMHBH48EAKDLCMRBH18BAKDLCMRBH36DAKDLCMRBH48EAKDLFSHBH09XAKDLFSHBH12XAJDLFSHBH12XAKDLFSHBH18XAKDLFSHBH24XAK
Other Carrier Mini-Split codes
All Carrier Mini-Split error codes →
Carrier code PC0F: homeowner questions
What does Carrier code PC0F mean?
PFC module protection. The PFC module signal to the main board is abnormal and the unit stops. Outdoor board shows E6 (it also shows E6 when this happens 3 times in 15 minutes); 48K HH shows J3.
Is it safe to keep using my ductless mini-split with code PC0F?
It depends on the cause. The ductless mini-split has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.
Can I reset Carrier code PC0F myself?
You can try one reset (power off for 30 seconds, then on). If Carrier code PC0F comes back, the cause is still there and a licensed technician should check it.
Who can fix Carrier code PC0F near me?
Aurora Star Tech Inc. repairs Carrier ductless mini-splits in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: AC Running But Not Cooling: What to Check · Heat Pump Not Heating or Blowing Cold Air
Troubleshooting guides
- Indoor unit leaking water All brands · Mini-Split
- Poor capacity / high head All brands · Mini-Split
- Water leaking All brands · Mini-Split
- Discharge the inverter capacitors before service Carrier · Mini-Split
- Display shows a strange code or does not answer the remote - DLFSHB indoor Carrier · Mini-Split
- Multi-zone: one room heats, another will not cool - DLC multi-zone Carrier · Mini-Split
- Read live data with the outdoor check button (SW1) Carrier · Mini-Split
- Run the automatic wiring / piping correction Carrier · Mini-Split
Source: DLCMRBH/DLCMHBH Multi-Zone Outdoor Service Manual (sold as Midea, Carrier and Viessmann Vitocal 200-S; Viessmann doc 6225551-03, 12/2024), Table 23 Outdoor Unit Error Display p.26; diagnosis p.56-57; Carrier MS-DLFSHB-01 High Wall Ductless Service Manual (04/2021), Table 9 p.17. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.