Icon
Reliable Heating and Cooling Solutions – Quality Service, Fair Prices, Guaranteed Satisfaction!

Gree Error Code JA: Abnormal pressure protection (Heat Pump)

Updated · by Aurora Star Tech Inc.

Gree error code JA on a heat pump means: Abnormal pressure protection. It is also called Gree diagnostic code JA.

High severityHeat PumpGree GMV6 Mini VRF

Homeowner? What Gree code JA means for you

Call a technician Your heat pump is reporting: Abnormal pressure protection. The heat pump has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.

Safe things you can check yourself

  • Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
  • Check both breakers and the outdoor disconnect box beside the outdoor unit; all should be ON.
  • Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
  • In winter, keep snow and ice off and away from the outdoor unit. A short defrost cycle with steam is normal.
  • Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.

Call (647) 657-2977Book a service call

Licensed technicians serving Vaughan, Toronto and the GTA.

What does Gree error code JA mean?

Pressures read abnormal, usually from a large refrigerant loss or a bad pressure sensor.

Applies to: Gree GMV6 Ultra Heat Mini VRF 36-60k (GMV-V..WL/C-T(U))

Common causes of Gree code JA

  • Severe undercharge
  • High or low pressure sensor fault
Safety: Gas, electrical and refrigerant work must be done by a licensed technician. Turn off power and gas before servicing, never bypass a safety control, and always follow the manufacturer's manual for your exact model.

Gree models that use code JA

GMV-V36WL/C-T(U)GMV-V48WL/C-T(U)GMV-V60WL/C-T(U)

Other Gree Heat Pump codes

CodeMeaning
HPInverter fan AC current protection
HUFan drive AC input voltage fault
J1Compressor overcurrent
J74-way valve gas mixing
J8High pressure ratio protection
J9Low pressure ratio protection
JFWiFi module fault
JLHigh pressure too low
L0Indoor unit fault
L1Indoor fan protection
L3Outdoor DC fan motor fault
L4Wired controller power fault

All Gree Heat Pump error codes →

Gree code JA: homeowner questions

What does Gree code JA mean?

Abnormal pressure protection. Pressures read abnormal, usually from a large refrigerant loss or a bad pressure sensor.

Is it safe to keep using my heat pump with code JA?

It depends on the cause. The heat pump has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.

Can I reset Gree code JA myself?

You can try one reset (power off for 30 seconds, then on). If Gree code JA comes back, the cause is still there and a licensed technician should check it.

Who can fix Gree code JA near me?

Aurora Star Tech Inc. repairs Gree heat pumps in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.

Homeowner help: AC Running But Not Cooling: What to Check · Heat Pump Not Heating or Blowing Cold Air

Troubleshooting guides

Source: Gree GMV6 Ultra Heat Mini VRF 36-60k (GMV-V36-48-60WL-C-T(U)) service.pdf - section Chapter 3 Faults, 4.1 Error Indication. Written in our own words as a summary; always check the original manual.

General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.

Emergency HVAC Service

647-657-2977