FlowMax Error Code E22: Parameter programming request (Combi Boiler)
FlowMax error code E22 on a combi boiler means: Parameter programming request. It is also called FlowMax diagnostic code E22.
Homeowner? What FlowMax code E22 means for you
Check, then call Your combi boiler is reporting: Parameter programming request. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Make sure the unit has power: its on/off switch (often looks like a light switch near the unit) is ON and the breaker in the electrical panel is not tripped.
- Look at the pressure gauge on the boiler. If it reads much lower than usual or near zero, or water is leaking, call a technician.
- Outside, make sure the intake and exhaust pipes or vent cap are not blocked by snow, ice, leaves or a nest.
- Check that the boiler gas valve is open (handle in line with the pipe).
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
- If only hot water is missing, check that the hot water tap is open far enough to start the heater.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does FlowMax error code E22 mean?
The board has lost its parameter memory and the parameters must be reprogrammed.
Applies to: FLOWMAX-90, FLOWMAX-120
Common causes of FlowMax code E22
- Loss of microprocessor memory
FlowMax models that use code E22
Other FlowMax Combi Boiler codes
All FlowMax Combi Boiler error codes →
FlowMax code E22: homeowner questions
What does FlowMax code E22 mean?
Parameter programming request. The board has lost its parameter memory and the parameters must be reprogrammed.
Is it safe to keep using my combi boiler with code E22?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset FlowMax code E22 myself?
You can try one reset (power off for 30 seconds, then on). If FlowMax code E22 comes back, the cause is still there and a licensed technician should check it.
Who can fix FlowMax code E22 near me?
Aurora Star Tech Inc. repairs FlowMax combi boilers in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: Tankless Water Heater No Hot Water: What to Check · Boiler Not Heating: What to Check
Source: FlowMax FLOWMAX-120 Instruction Manual, 6.10 Troubleshooting table, p.66; FlowMax FLOWMAX-120 Instruction Manual, 6.11 Diagnostics error code list, p.67; FlowMax FLOWMAX-90 User Manual, Diagnostics - Error codes, p.8-9; FlowMax FLOWMAX-120 Instruction Manual, 5.2 Setting the parameters, p.40. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.