Bosch Error Code F41: High pressure sensor fault (Heat Pump)
Bosch error code F41 on a heat pump means: High pressure sensor fault. It is also called Bosch diagnostic code F41.
Homeowner? What Bosch code F41 means for you
Check, then call Your heat pump is reporting: High pressure sensor fault. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Check both breakers and the outdoor disconnect box beside the outdoor unit; all should be ON.
- Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
- In winter, keep snow and ice off and away from the outdoor unit. A short defrost cycle with steam is normal.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Bosch error code F41 mean?
The high-side pressure sensor signal is faulty.
Applies to: Bosch IDS Light BOVA15-24/36/60 and IDS Premium Connected BOVA36-20/60-20 R-454B heat pump outdoor units
Common causes of Bosch code F41
- Loose CN16 wiring
- Failed transducer
- Control board
Bosch models that use code F41
BOVA15-24BOVA15-36BOVA15-60BOVA36-20BOVA60-20
Other Bosch Heat Pump codes
All Bosch Heat Pump error codes →
Bosch code F41: homeowner questions
What does Bosch code F41 mean?
High pressure sensor fault. The high-side pressure sensor signal is faulty.
Is it safe to keep using my heat pump with code F41?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset Bosch code F41 myself?
You can try one reset (power off for 30 seconds, then on). If Bosch code F41 comes back, the cause is still there and a licensed technician should check it.
Who can fix Bosch code F41 near me?
Aurora Star Tech Inc. repairs Bosch heat pumps in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: AC Running But Not Cooling: What to Check · Heat Pump Not Heating or Blowing Cold Air
Source: Bosch IDS Light installation BTC 762003308 D (02.2025), Fault Code Table 23 and 17.12 Error Code Troubleshooting, p.42-59; Bosch IDS Premium Connected installation BTC 762003301 D (02.2025), Fault Code Table 22 and 18.12 Error Code Troubleshooting. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.