Bosch Error Code Gateway power LED 2 blinks: Gateway power LED (green) 2 blinks – booting (Heat Pump)
Bosch error code Gateway power LED 2 blinks on a heat pump means: Gateway power LED (green) 2 blinks - booting. It is also called Bosch diagnostic code Gateway power LED 2 blinks.
Homeowner? What Bosch code Gateway power LED 2 blinks means for you
Usually minor Your heat pump is reporting: Gateway power LED (green) 2 blinks - booting. This code is usually informational or minor. The safe checks below often clear it; call us if it keeps showing up.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Check both breakers and the outdoor disconnect box beside the outdoor unit; all should be ON.
- Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
- In winter, keep snow and ice off and away from the outdoor unit. A short defrost cycle with steam is normal.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Bosch error code Gateway power LED 2 blinks mean?
Two blinks per cycle on the green power LED mean the gateway is starting up. At start-up the LEDs can also show a sequence for up to 6 minutes while the gateway installs a firmware update. Normal.
Applies to: IDS Premium Connected gateway
Bosch models that use code Gateway power LED 2 blinks
Other Bosch Heat Pump codes
All Bosch Heat Pump error codes →
Bosch code Gateway power LED 2 blinks: homeowner questions
What does Bosch code Gateway power LED 2 blinks mean?
Gateway power LED (green) 2 blinks - booting. Two blinks per cycle on the green power LED mean the gateway is starting up. At start-up the LEDs can also show a sequence for up to 6 minutes while the gateway installs a firmware update. Normal.
Is it safe to keep using my heat pump with code Gateway power LED 2 blinks?
Usually yes. Code Gateway power LED 2 blinks is normally minor, but if it keeps coming back have it checked.
Can I reset Bosch code Gateway power LED 2 blinks myself?
You can try one reset (power off for 30 seconds, then on). If Bosch code Gateway power LED 2 blinks comes back, the cause is still there and a licensed technician should check it.
Who can fix Bosch code Gateway power LED 2 blinks near me?
Aurora Star Tech Inc. repairs Bosch heat pumps in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: AC Running But Not Cooling: What to Check · Heat Pump Not Heating or Blowing Cold Air
Troubleshooting guides
- Force cooling for charging with the FORCE button Bosch · Heat Pump
- Pair the gateway by Bluetooth (Connect button) Bosch · Heat Pump
- Read system values with the CHECK button (point check) Bosch · Heat Pump
- Restart the gateway (Reset button) Bosch · Heat Pump
- Run the gateway diagnostic (Factory + Connect buttons) Bosch · Heat Pump
- Start a manual defrost test (hold FORCE 6 s) Bosch · Heat Pump
Source: Bosch IDS Premium Connected BTC 762003301 D (02.2025), Gateway light indications table (troubleshooting section) and 20 Gateway Functionality p.69. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.