Trane Error Code F6: Drive high temperature fault (AC)
Trane error code F6 on a air conditioner means: Drive high temperature fault. It is also called Trane diagnostic code F6.
Homeowner? What Trane code F6 means for you
Call a technician Your air conditioner is reporting: Drive high temperature fault. The air conditioner has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Check both breakers and the outdoor disconnect box beside the outdoor unit; all should be ON.
- Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
- Keep about 2 feet around the outdoor unit clear of leaves, grass and debris.
- If you see ice on the pipes or the indoor coil, turn the system off and run only the fan for a few hours, then call a technician.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Trane error code F6 mean?
Compressor IPM, fan IPM or PFC section overheated. Manual lists only the meaning (A1000BA board); steps are general checks drawn from other sections of the guide.
Applies to: Trane 5TTR7 multi-speed AC (5TTR7024A-060A)
Common causes of Trane code F6
- Blocked airflow over drive/coil
- Dirty coil
- Very high ambient
A technician checks these and 1 other possible causes on site before replacing any part.
Trane models that use code F6
5TTR7024A5TTR7036A5TTR7048A5TTR7060A
Other Trane AC codes
All Trane Air Conditioner error codes →
Trane code F6: homeowner questions
What does Trane code F6 mean?
Drive high temperature fault. Compressor IPM, fan IPM or PFC section overheated. Manual lists only the meaning (A1000BA board); steps are general checks drawn from other sections of the guide.
Is it safe to keep using my air conditioner with code F6?
It depends on the cause. The air conditioner has locked out or cannot run properly. One reset is fine; if the code comes back, it needs a licensed technician to find the cause.
Can I reset Trane code F6 myself?
You can try one reset (power off for 30 seconds, then on). If Trane code F6 comes back, the cause is still there and a licensed technician should check it.
Who can fix Trane code F6 near me?
Aurora Star Tech Inc. repairs Trane air conditioners in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Homeowner help: AC Running But Not Cooling: What to Check
Troubleshooting guides
- Not cooling All brands · Air Conditioner
Source: Trane ODR-SVN002E-EN (5TTR7/5TWR7 installer's guide) - section Integrated Variable Speed Control Board LED Indicators, Table 18 (A1000BA models). Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.