Bosch Error Code 2 flashes: Indoor T2 sensor fault (Air Handler)
Bosch error code 2 flashes on a air handler means: Indoor T2 sensor fault. It is also called Bosch diagnostic code 2 flashes.
Homeowner? What Bosch code 2 flashes means for you
Check, then call Your air handler is reporting: Indoor T2 sensor fault. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Safe things you can check yourself
- Check the thermostat: right mode (Heat or Cool), set a few degrees past room temperature, and fresh batteries if it uses them.
- Make sure the unit has power: its on/off switch (often looks like a light switch near the unit) is ON and the breaker in the electrical panel is not tripped.
- Look at the air filter. If it is grey and clogged, replace it; a blocked filter causes many shutdowns.
- Try one reset: turn the power off for 30 seconds, then back on. If the code comes back, stop resetting and call a technician.
Call (647) 657-2977Book a service call
Licensed technicians serving Vaughan, Toronto and the GTA.
What does Bosch error code 2 flashes mean?
The coil temperature sensor reads faulty.
Applies to: Bosch IDS Plus/Premium BIVA20 R-454B air handlers (2-5 ton)
Common causes of Bosch code 2 flashes
- Sensor not seated
- Failed sensor
Bosch models that use code 2 flashes
BIVA20-24BIVA20-36BIVA20-48BIVA20-60
Other Bosch Air Handler codes
All Bosch Air Handler error codes →
Bosch code 2 flashes: homeowner questions
What does Bosch code 2 flashes mean?
Indoor T2 sensor fault. The coil temperature sensor reads faulty.
Is it safe to keep using my air handler with code 2 flashes?
It depends on the cause. This is often caused by something simple. Try the safe checks below; if the code returns, book a service call before it turns into a no-heat or no-hot-water emergency.
Can I reset Bosch code 2 flashes myself?
You can try one reset (power off for 30 seconds, then on). If Bosch code 2 flashes comes back, the cause is still there and a licensed technician should check it.
Who can fix Bosch code 2 flashes near me?
Aurora Star Tech Inc. repairs Bosch air handlers in Vaughan, Toronto and across the GTA. Call (647) 657-2977 or book a service call online.
Source: Bosch IDS Plus/Premium air handler BIVA20 installation BTC 762003302 C (10.2024), section 13 LED Flashing Troubleshooting, p.49-50. Written in our own words as a summary; always check the original manual.
General guidance for qualified technicians. The manufacturer's installation and service manual and local codes always take priority. Aurora Star Tech is not affiliated with, endorsed by or sponsored by any equipment manufacturer; brand and model names are used only to identify equipment and belong to their owners.