Furnaces and heating
Furnace Repair and Heating Services in the GTA
A furnace usually gives up on the coldest night of the year. We fix ignition, pressure switch, limit and blower problems on every major make, replace furnaces that are past saving, and do the yearly tune-up that keeps the warranty valid and the heat exchanger safe.
Our heating services
Furnace repair
Failed igniters, dirty flame sensors, pressure switch and inducer faults, limit lockouts, blower motors and control boards. We read the flash code first, then test before we replace anything.
Furnace installation
High-efficiency furnaces sized to your home, not to the old unit. New venting, condensate drain and thermostat wiring done properly, then a combustion and temperature-rise check.
Furnace maintenance
Burner and flame sensor cleaning, gas pressure, heat exchanger inspection, filter, condensate trap and a carbon monoxide check. Once a year, ideally before the first cold week.
Heating system checks
Uneven rooms, short cycling or a furnace that runs and never catches up. We find out whether it is airflow, sizing, ductwork or the thermostat.
Browse the furnaces we install →Models, specs and a quote request, all in one place.
When to call about your furnace
- The furnace runs but blows cold air
- It starts, shuts off after a minute and tries again
- A blinking light or code on the control board
- New noises: banging at start-up, squealing, rattling
- Gas bills climbing while the house feels the same or colder
- The furnace is 15 to 20 years old and needs a costly part
Repair or replace?
If a furnace is under about 12 years old and the repair is a common part, repairing almost always makes sense. Past 15 years, with a cracked heat exchanger or a failed control board, a new high-efficiency unit usually costs less over the next decade.
We give you both numbers and let you decide. Installation estimates are free and financing is available.
Furnace flashing a code?
Look up the blink code to see what it means and what to check first.
How a visit works
Step 1
Call or book online
Tell us the equipment and what it is doing. If it shows an error code, have it ready; it often tells us which part to bring.
Step 2
Diagnosis and a clear price
A technician tests the system, shows you what failed and gives you the price. You decide before any work starts.
Step 3
Fixed, tested, cleaned up
We finish the repair or install, run the system through a full cycle and leave the area as we found it.
Seeing a code on the display? Look it up first in our HVAC error code library.
Furnaces and heating: common questions
Do you offer emergency furnace repair?
Yes, emergency heating service is available 24/7 across the GTA. Call and tell us what the furnace is doing.
How long does a furnace installation take?
Most replacements are done in one day, including the thermostat and a full start-up check.
Which furnace brands do you install?
We install AirQuest, KeepRite, Carrier, Lennox, Amana, Goodman, Trane, York and other major brands, and service all makes.
Is a yearly tune-up really necessary?
Most manufacturers require annual maintenance to keep the parts warranty, and it is the only regular check of the heat exchanger and carbon monoxide levels.
Need a technician today?
Emergency service is available 24/7 in Vaughan, Toronto, Richmond Hill, Markham, Mississauga and across the GTA.